This enables the application system to be set up and fine tuned prior to the curing process. In turn, this will reduce the amount of scrap and over-spray.
Place the comb into the powder and slide the comb along the surface. The measurement points (or teeth) are pointed and allow the powder to flow around them.
The thickness of the powder lies between the highest value where a drag mark is visible and the lowest value where a drag mark has not been produced.
Note: The thickness of a coating prior to cure is not the same value after curing but there is a correlation. The powder comb is suitable as a guide only.
The Elcometer 155 is not available for sale in the USA.
|B15513573-5||Elcometer 155 Metric Powder Film Comb||50 - 255µm||ο|
|B15513573-6||Elcometer 155 Metric Powder Film Comb||225 - 1250µm||ο|
|B15513573-1||Elcometer 155 Imperial Powder Film Comb||2 - 9 mils||ο|
|B15513573-2||Elcometer 155 Imperial Powder Film Comb||9 - 50mils||ο|
|B15513573-10||Metric Comb Set (2 combs)||50 - 225µm and 225 - 1250µm||ο|
|B15513573-9||Imperial Comb Set (2 combs)||2 - 9mils and 9 - 50mils||ο|
|Dimensions||38mm x 46mm (1.5” x 1.8”)|
|Packing List||Elcometer 155 Powder Comb and powder comb wallet for two combs|
ο Optional Calibration Certificate available